Screws (4)
Wall Anchors (4)
CAUTIONS: BATTERY INSTRUCTIONS
PRE INSTALLATION
•Do not expose the light to fire or intense heat.
•Do not immerse in water.
•Your motion light and solar panel are both weather-resistant.
•Never look directly into the solar motion light when illuminated.
HARDWARE INCLUDED
(
note:
some parts may be pre-assembled)
USE RECHARGEABLE BATTERIES ONLY.
•Always purchase the correct size and grade of battery most suitable for the intended
use.
•Remove batteries from equipment which is not to be used for an extended period of
time.
•Dispose of the battery in accordance with local, state and federal regulations. (Do not
burn or discard the battery in a municipal water system or other body of water.)
CARE AND MAINTENANCE
CARE & MAINTENANCE
•From time to time, ensure the plug between the solar panel and light is securely
connected.
•The solar panel should be cleaned with a damp cotton cloth on a regular basis.
This will ensure optimal performance and battery charging.
•Never let any abrasive material come into contact with the solar panel.
INSTALLATION
ITEM: Q75AD1425-06
SAFETY INFORMATION
05/09/2017
1/2 E
A
B
c
PARTS
A - Light Fixture
B - Solar Panel
C - Mounting Bracket
INSTALLING THE LIGHT
FIXTURE
4
Mark the hole locations of the mounting
bracket, then set the mounting bracket
aside. Check that the marked areas are
clear of obstacles such as cables and
electrical lines. Drill holes for the enclosed
screws and wall anchors. Insert the wall
anchors then secure the mounting bracket
in place with the screws.
INSTALLING THE SOLAR PANEL
1
CONNECTING THE WIRES
Carefully route the power cord of the
solar panel to the light fixture and plug
into the socket located on the light.
Only use solar panels for power charging.
It is not allowed to access other external
charging equipment.
Locate the mounting bracket six to eight
feet above ground on a solid surface
capable of supporting the light fixture
and secure enough so that it will not move
when exposed to vibrations or wind. The
light fixture must be high enough to allow
for motion detection and light distribution.
2
3
MOUNTING THE SOLAR PANEL
ON THE MOUNTING BRACKET
Slide the mounting bracket into the slot on
the back of the solar panel.
Option 1:
Slide the light fixture into the fixed block
on the back of the mounting bracket.
5
Mark the hole locations of the light
fixture, then set the light fixture
aside. Check that the marked areas are
clear of obstacles such as cables and
electrical lines. Drill holes for the enclosed
screws and wall anchors. Insert the wall
anchors then secure the light fixture
in place with the screws.
Option 2:
WARNING:
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with these instructions
could result in a potentially fatal electric shock and/or property damage.
