5 of 9
ISSUED: 05-21-04 SHEET #: 201-9226-1
Visit the Westinghouse Web Site at www.westinghousedigital.com
For customer service call
1-866-287-5555
.
E
C
H
I
Insert holding pin (
H
) into wall support arm axle (
C
). Insert axle (
C
) through wall bracket (
A
) and lower swing arm (
E
).
Lock axle (
C
) in place with holding pin (
H
).
IMPORTANT: Be sure swing arm (E) is in correct position shown
below with plastic cap at top.
Next thread snap ring (
I
) into groove at bottom of axle (
C
) protruding from wall bracket (
A
) as shown.
SNAP RING INSTALLATION:
Pull snap ring (
I
) apart. Wind it around the tube while feeding it into the groove.
Finish by snapping the end of the snap ring into groove.
NOTE:
Fit of axle (
C
) into wall bracket (
A
) and lower swing arm (
E
) will be tight.
Gently tap into place with a hammer if necessary.
A
Insert swivel weldment (
B
) through swing arm (
E
).
Align holes in swivel bracket (
D
) with holes in swivel weldment (
B
) and secure with four M6 x 10 mm phillips screws
(
M
) as shown.
M
B
D
B
D
E
• Failure to correctly mount swing arm with plastic cap at top as shown in detail 3 will result in product failure.
• Improperly installed snap rings will result in product failure.
• If you are uncertain that product is properly installed, call customer service.
WARNING
I
H
E
groove
1
3
2
groove
I
C
pre-installed snap ring
DETAIL 3