6 of 8
ISSUED: 02-08-06 SHEET #: 202-9093-1
2
fig 2.1
Note:
"X" dimensions should be equal.
Notes:
• Always use multi-washers when attaching
tilt brackets (
BB
and
CC
) to your screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown in figure 2.2.
• Spacers may not be used, depending upon
the type of screen.
• Tighten screws so adapter brackets are firmly
attached. Do not tighten with excessive force.
Overtightening can cause stress damage to screws,
greatly reducing their holding power and possibly
causing screw heads to become detached.
Tighten to
40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen
inserts or if screws bottom out and bracket is still not
tightly secured, damage may occur to screen or
product may fail.
WARNING
Installing Tilt Brackets
BB
CENTER BRACKETS
VERTICALLY ON
BACK OF SCREEN
X
CC
Refer to
Screen Compatibility Chart
to determine the proper fasteners to use.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.
Place tilt brackets (
BB
and
CC
) on back of screen. Align to holes, and center on back of screen as shown in figure
2.1. Attach the tilt brackets to the back of the screen using the appropriate combination of screws, multi-washers,
and spacers as shown in figure 2.3.
Note:
Be sure to attach tilt brackets with knobs facing outward as in figure 2.1.
Note:
Top and bottom mounting holes must be used for attaching brackets. Middle holes should also be used where
the fasteners and screens allow.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver or security wrench (
FF
)
depending on the fasteners used.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
fig. 2.2
MULTI-
WASHER
SPACER
MULTI-WASHER
SCREW
BB
CC
fig 2.3
X
