2
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-5853935-RevA
ECO #: W18-0191
DATE: 03/26/19
PROCEDURE
1. Remove contents from box, verify if all parts listed are present and free from damage.
Carefully read and understand all instructions before attempting installation.
Failure to identify damage before installation could lead to a rejection of any claim.
2. Start installation on driver’s side. On the rocker panel find locations of factory studs. In each location there should be 3
studs.
See Figure 1.
3. Insert (1) M8 Plastic Retainer (Item 13) on each factory stud.
See Figure 2.
4. Insert the M8 round head square neck bolt (Item 9) through the Mounting Bracket C (Item 5) square hole. Then insert the
M8 round head square neck bolt through mounting brackets (Item 3-5) bottom circular hole. Loosely secure with (1) M8
hex nut, (1) M8 split lock washer, and (1) M8 flat washer.
See Figure 3.
5. Align sub-assembly with the 3 factory studs. Lower 2 factory studs will align with Mounting Bracket C and top factory
stud will align with mounting brackets. Loosely secure sub-assembly with (3) M8 hex nut, (3) M8 split lock washer, and
(3) M8 flat washer.
See Figure 4.
(Note: See page 3 for bracket orientation)
6. Repeat
Step 3-4
for ever y mounting location.
Figure 1
Factory studs shown
Front Driver side shown
Figure 2
12
Figure 3
Front Driver
Side Mounting
Location Shown
Figure 4
13
9
5
3
7
6
8
8
6
7
