4
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-0026-RevF
ECO #: W17-0060
DATE: 6/21/17
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
(Figure 7B) Driver side Front Sup-
port Bracket for 4WD Vehicles
With Transfer Case Skid Plate Only
Front
(Figure 7A) Driver side Front Support Bracket Instal-
lation for 4WD Vehicles With Transfer Case Skid
Plate Only. NOTE: Move Outer Support Bracket to
back of Mounting Bracket.
(2) M10 x 35mm Hex Bolts
(4) M10 Flat Washer
(2) M10 Nylon Lock Nuts
Replace factory hex bolt with:
M10 x 40mm Hex Bolt
M10 Lock Washer
M10 Flat Washer
Front
Outer Support Bracket
(1) M12 Bolt Plate
(1) M12 Small Flat Washer
(1) M12 Lock Washer
(1) M12 Hex Nut
(Figure 8A) Driver side rear
Mounting Bracket location.
(Figure 8B) M10
Long Bolt Plate
Rear
Figure 9B
Figure 9A
6. Next, select the Driver Side Rear Mounting Bracket. Bolt the Mounting Bracket to the back of the pinch weld with (2) M6
hex bolt, (4) M6 flat washers and (2) M6 nylon lock nut. See
Figure 10.
Hang the Bracket from the previously installed
forward Bolt Plate with (1) M10 flat washer, (1) M10 lock washer and (1) M10 hex nut. See
Figure 10.
Line up the hole in
the Outer Support Bracket with the hole in the Mounting Bracket. Bolt the Brackets together with (1) M10 x 30mm hex
bolt, (2) M10 flat washers, (1) M10 nylon lock nut. See
Figures 11 & 13
. Do not tighten hardware at this time.
7. Select the driver side Rear Inner Support Bracket. Bolt the Support Bracket to the back of the Mounting Bracket with (1)
M10 x 30mm hex bolt, (2) M10 flat washers and (1) M10 nylock nut. See
Figures 11 & 12.
Do not tighten hardware.
8. Select the Sidebar and carefully place it in position on the (2) Mounting Brackets. Line up the threaded holes in the Sidebar
with the slots in the Brackets and bolt it in place with the included (4) M8 hex bolts, (4) M8 lock washers and (4) M8 flat
washers. See
Figure 13.
Snug all hardware but do not tighten at this time.
9. Adjust bar as needed and tighten all hardware at this time. Torque all M12 fasteners to 45-50 ft lbs, M10 to 30-35 ft lbs,
M8 to 15-18 ft lbs, and M6 to 7-8 ft lbs.
10. Repeat
Steps 2 - 9
for passenger side.
Note:
Remove wire harness prior to installing brackets on passenger side. Remove
(4) M10 nuts to remove the wire harness. See
Figure 15
.
11. Reattach the wire harness to the vehicle using the (4) M10 nuts.
