FCC ID: NKBTX3-9V
Installation
Fasten the TX3-9V on the car or motorcycle using pop rivets or some other suitable fastening. Be sure to place all
transmitters in the same location on each vehicle. The best possible orientation of the transmitter is shown below
with the longest edge of the transmitter parallel to the Start/Finish line where the loop antenna is located.
Maintenance
The TX3-9V requires minimal maintenance. Cleaning the spring battery contacts can be done with a damp cloth or
cotton swab. The external plastic may be cleaned with a damp cloth. Do not use solvents to clean either the plastic
or the battery contacts.
Specifications
Specification
Dimensions
Approx. 3.25” x 2” x 0.75”(
≈
8x5x2cm)
Weight
Approx. 4oz(100 grams)
Temp Range
32-122
°
F (0-50
°
C)
Battery Life
72 Hours Nominal(100 Typical)
Operational Indicator
LED
Low Battery Indicator
LED
Humidity
100% Relative
FCC Notice
FEDERAL COMMUNICATIONS COMMISSION RADIO AND TELEVISION
INTERFERENCE STATEMENT
Changes or modifications not expressly approved by
Westhold Corporation
could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received including interference that may cause undesired operation.
FCC ID: NKBTX3-9V
Direction of Travel
