INTERFACE
Loading interface
The loading logo interface is displayed for 3 seconds after the
display is turned on. When the communication connection is
established, the display enters the main interface which shows
information obtained from the controller.
fb.com/westhillbikes
|
westhillbikes.com
10
SPECIFICATIONS
- Power supply: DC 24V/36V/48V
- Rated current: 18 mA
- Shutdown leakage current: <1uA
- Screen specification: 1.3" OLED
- Communication method: UART/ CAN-BUS 2 modes
- Operating temperature: -20° C ~ 60° C
- Storage temperature: -30° C ~ 80° C
- Waterproof level: IP65
FUNCTION OVERVIEW
- Four buttons, ergonomic design
- Selective digital and icon power assist gear for high visibility
- Unit: km/ miles
- Speed: Real-time speed (SPEED), maximum speed (MAX), average speed (AVG)
- Battery indicator with percentage display
- Range: Endurance mileage (*available if BMS provides necessary info)
- Headlight on/off status indication and control
- Mileage: Subtotal mileage (TRIP), total mileage (ODO)
- Walk assist function
- Parameters setting and advanced setting
- Error code indication
INSTALLATION
1. Open the display locking clip and set the display on the left handlebar
(standard handlebar size: Ø22.2). Adjust the display so it is in a position to be
easily and comfortably operated whilst seated upon the bike. Use the 3mm
hex drive to tighten. Tightening torque: 0.8N.m.
*Note: Damage caused by excessive torque is not covered by the warranty.
2. Connect the 5 pin plug to the docking plug of the controller as marked.
Summary of Contents for LINK
Page 24: ...westhillbikes com ...
