1.
2.
3.
4. Ensure the On/Off Button and the Test button has been pressed before installation.
5. Using the dedicated tool to assemble the light body and the mounting accessories, adjust the light fixture and LED module toa
suitable angle.
6. Install the light to the round pole, square pole, or wall; tighten the screws and the nuts when fixed
Installation steps
5
Phone: (877) 805-2252 | Fax: (877) 805-2252
www.westgatemfg.com |
1.
2.
3. Cover the solar panel and check if the light module turns on
4. Press the test button on the remote control to test if the function is normal and set the necessary operation mode. Thelight
module will flash twice when receiving the signal from the remote control. The default setting is Induction mode20%-80%
Open the package and do inspection
Step By Step Installation guide
1. guide1.Take out the fixture and the tools from the package.
2. Press the ON/OFF key on the remote control and check whether it shows red light on the sensor. If still not, use adedicated
charger to charge
Charging point, DC14.6V 5A MAX
