W
ESTFIELD
- G
RAIN
A
UGERS
5. O
PERATION
MK 130 P
LUS
X
61’ - 81’
30259
61
2. When auger is clear of grain, disengage PTO drive.
3. Shut down and lock out tractor.
E
MERGENCY
/ F
ULL
-T
UBE
R
ESTART
:
1. If cleanout covers or safety doors have been opened or removed, close or
replace them before restarting the unit.
2. If the auger is shut down for an emergency, lock out tractor before correcting
the problem.
• If the problem is plugging, clear as much of the grain as possible using a
piece of wood, wet/dry vac, or other tool before restarting auger.
Do not
reach in and use your hands
even if the tractor has been locked out.
3. If auger tube is full of grain, do not restart at full speed. Engage PTO at low
rpm, gradually increasing power until normal operating speed is reached.
5.4.4. L
OWERING
& C
OMPLETION
After operation:
1. Clean entire work area.
2. Remove all supports and chocks.
3. Move
auger
out
of working position and lower fully (see shaded box that
follows for lowering procedure).
4. Move
auger
to
the next work area or to a storage area and then clean out.
NOTICE
Starting the auger when there is grain blockage will result in
damage.
Summary of Contents for MK 130 PLUS 71
