16
Using
2.
Press “M” (3) and
“Peak/Trace” (4) to-
gether and the small
arrow symbol (B) will
move one column to the
left.
When the arrow symbol
reaches the very left
position (K-cm) it will jump
back to “N-m” and continue moving one step left
each time the button combination in pressed.
This setting will be stored internally. When the
digital torque adaptor is switched on again the
previously stored “unit” will be active again.
Do not press “M” (3) and “Power” (2) buttons
together. The system will enter the calibration
mode. Calibrating must only be performed by a
professional calibration service.
Using
Attach the wrench to the ½” socket (1) and apply
the desired torque.
Before you approach the set up torque value
(approx. 20 units) you will see a red flash light and
B
