![background image](http://html1.mh-extra.com/html/westfalia/82-73-29/82-73-29_instruction-manual_963468015.webp)
10
Operation
1. Before attaching the tool draw back the
plastic cap of the tool chuck (see
picture).
2. Now insert the tool into the chuck as
deep as it will go.
3. Release the cap. It will slide forward
and the tool will be hold in place by the
steel balls in the chuck.
4. Check the secure grasp of the chuck by pulling on the tool. It must move in
the chuck, but not come out.
7. To remove the tool, pull back the plastic cap. Now you can pull the tool out
of the chuck.
When the hammer function is used, there is a constant mechanical friction
between the chuck and the tool shaft. Coat the end of the tool shaft with a light
coat of machine grease at regular intervals.
Turning ON and OFF
The ON and OFF switch is located in front of the
handle. To turn ON, push the switch to the right, to
turn OFF, push it to the left.
Setting the Impact Frequency
1. The unit is equipped with a
step less impact frequency
regulator, which allows
working in a manner
appropriate to the material.
2. Using the regulator you can
set impact frequencies
between 900 and 1800
impacts per minute. Please
set the impact frequency
according to the material you are working on.
Summary of Contents for 82 73 29
