![background image](http://html.mh-extra.com/html/westfalia/81-25-06/81-25-06_instruction-manual_963669020.webp)
15
Operation
Before first Use
Take the circular saw out of the packaging. Check the saw for damage in
transit. Do not use the device if it is damaged.
Keep packaging materials away from children. There is a risk of suffocation!
Disconnect the circular saw from power mains before working on it.
Adjusting the Cutting Depth
The saw blade may stick out of the
component by 3 mm. Only then the impact
angle of the saw blade’s teeth is ideal.
1. Loosen the adjusting screw (16) to
adjust the cutting depth.
2. You can adjust the cutting depth desired
with the scale (15).
raising
lower cutting depth
lowering
higher cutting depth
3. Tighten the adjusting screw again.
Cutting Marks on the Base Plate
On the base plate you will find two cutting marks. The one cutting marks is a
notch-shaped cutting marks (17) and the other cutting mark (7) is a rhomb-
shaped notch. The notch-shaped cutting mark shows the position of the saw
blades for right-angled cuts. With the rhomb-shaped cutting mark it is easier to
make clear cuts along the cutting line.
Always consider the
thickness of the saw
blade when cutting.
Always conduct the saw
blade outside the cutting
line of the work piece.
It is recommended to
make a trial cut before
starting to work!
16
15
7
17