8
Using
Inserting a Glue Stick
Insert one glue stick into the rear end of the glue gun and push it
in as far as you can. Press the trigger to make sure that the stick
is solidly pressed against the heater unit.
Operation
1. Connect the unit to a power outlet. The glue gun immediately
starts heating up. Wait some minutes.
2. Set the glue gun on its wire support and wait until some glue
is molten and appears in the nozzle. When the trigger is
pressed molten glue is forced out of the nozzle.
3. Put some molten glue onto the dry, clean surface you want to
use and immediately press the work piece you want to glue
down into the molten glue. The glue solidifies almost
immediately and forms an instant bond. Press the glued parts
together for several seconds.
4. When the stick cannot be pushed any further by the trigger,
put in a new stick. Do not try to take out the old one, simply
put in a new stick.
The old stick remains in the gun until it has been completely
melted when using the unit next time.
Cleaning and Storing
Before working on the tool, disconnect the plug from the
power.
Clean the device only with a lightly dampened cloth. Never
immerse it into water or sprinkle it with water.
