Lit. No. 43572/43582/43592, Rev. 02
12
January 1, 2017
NOTE: Periodically throughout the snow and ice
control season, verify that mounting devices
are secure.
1. Remove the tailgate from the pickup bed.
2. Load the spreader onto the truck bed.
3.
Mount the chute to the deflector using the supplied
hardware kit.
4.
Mount the chute/deflector assembly to the spinner
assembly with supplied hardware to form the drive
assembly.
5. Mount the drive assembly to the spreader with a
bent pin and secure with a hairpin cotter.
6.
Slide the spreader forward until the deflector/chute
assembly makes contact with the vehicle. Then
slide spreader back approximately 1" to allow
proper clearance.
7. Install stop bars using supplied hole patterns (see
illustration below). If the holes are not present or
do not align in this position, refer to the Installation
Instructions.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
CAUTION
Before lifting, verify that hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie‑down chains or straps
alone to hold spreader in vehicle.
Through Floor/Bed
Mounting Fasteners
Adjustable Stop Bracket
CAUTION
Before drilling any holes, check both sides
of the material for any wires, fuel lines, fuel
tanks, etc., that may be damaged by drilling.
MOUNTING THE SPREADER