Manuale Utente LED12.BB-12/24-350-XP
User Manual LED12.BB-12/24-350-XP
Rev. 1.0
06-11-2014
This document is the property of WESTERN CO S.r.l.. All rights are reserved.
Reproduction and use of information contained within this document is
forbidden without the written consent of WESTERN CO S.r.l..
LUMINOUS FLUX REDUCTION
The reduction of luminous flux of
LED12.BB-12/24-350-XP
can be managed in two ways:
OPERATED BY A WESTERN CO. EXTERNAL CHARGE CONTROLLER
AUTOMATIC INTERNAL
In both cases the unit flux reduction is
30%
.
OPERATED BY A WESTERN CO. EXTERNAL CHARGE CONTROLLER
The
DIMMER
pole
the goes out from the unit has to be connected to the relative dimmer output of
Western Co. charge controller. Western Co. PV charge controllers to be used are the series
SPB-Lx
and
SPC07IP
.
Such charge controllers and LED12.BB-12/24-350-XP communicate through a Western Co. protocol; therefore
this mode of luminous flux reduction can be made only using the above mentioned charge controllers.
LED12.BB-12/24-350-XP
will reduce its own luminous flux when communicated by the charge controller.
AUTOMATIC INTERNAL
The LED luminaire can manage the reduction of luminous flux autonomously short-circuiting the
DIMMER
pole
to
–VDC.
In doing so the device will automatically reduce its luminous flux of 30%, 6
hours after being turned on.
Flux
Timer
6 hours
100%
70%
ATTENTION
1) Both the base anchors and the surface where the base will be mounted must be strong enough to
support the loads applied
2) Replace damaged protective shields with Western Co spare parts only
3) Respect the right polarities and avoid shor-circuits, they are destructive and void the warranty
4) The LED light source and the LED driver contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person
