Western IDRA ISKOV2-18 C6, Use And Installation Manual, Page: 7 / 24

INSTALLATION MANUAL IDRA
7
3. INSTALLATION
INS CAT
3.1 PLACE OF INSTALLATION
3.2 HYDRAULIC AND REFRIGERATION CIRCUITS
MINIMUM DISTANCES
15 cm
15 cm
50 cm
top
left/right sade
30 cm
30 cm
3.3 HYDRAULIC COMPONENTS
3.4 REFRIGERATION CONNECTIONS
The installation location should be agreed with the customer,
paying attention to the following points:
- The equipment should be placed in a technical room of
adequate size and in accordance with applicable regulations
in the countries where it will be installed.
- The condensing unit must not be installed outdoors.
- The plan on which will be supported to be able to support
the weight, the rubber feet that is attached to the machine
SHOULD NOT BE REMOVED except in case of use of anti-
vibration spring for installations with wall bracket.
The installer is responsible for the correct selection and
application of components according to current national
standards and as recommended below.
The hydraulic connections are made on the fittings located on
the right side of machine.
The hydraulic connections are distinguished by labels that
indicate the flow: WATER INLET AND OUTLET. Provide and
interception tap on the water inlet, use piping with an internal
diameter that corresponds to the diameter of the condensing
The refrigeration connections are made on the fittings located
on the right side of the unit. The connections on
- The front panel must be inspected, so the front space
should be adequate to permit the operator with all the steps
required during installation, maintenance and assistance
(controls, adjustments, refrigerant charge).
- In case of multiple installations (2 or more IDRA) DO NOT
STACK the condensing units.
- The installation must allow authorized personnel to
intervene in case of maintenance, in an easy manner which
respects both the safety distances between the unit and
other equipment that the technical areas mentioned below:
unit’s fittings because otherwise operation problems may
result (the guarantees voided if improper piping is used).
warning: always mount the inspection filter on the water
inlet and ensure the correct positioning of the filtering
unit respect minimum diameters required on the unit,
check the water supply flow.
the refrigeration lines are “flare” connections.