Lit. No. 85308, Rev. 04
5
July 15, 2020
INSTALLATION INSTRUCTIONS
UNPACKING
1. Set aside the blade guides, parts bag, and
headlamp bag.
2. Remove the receivers by pulling out the hitch pin
and rotating the hitch pin to lock into the notch on
the receiver.
3. Remove the cable ties that hold the blade
assembly to the pallet.
4. Remove the fasteners and strapping that secure
the A‑frame to the pallet.
A‑FRAME TO BLADE ASSEMBLY
1. Insert the nose of the A‑frame into the quadrant
and align the pivot bolt hole on the A‑frame with
the pivot bolt hole on the quadrant. Loosen and
remove both trip springs and tip the blade forward.
Insert the pivot tube through the quadrant into the
A-frame, tapered end first.
2. Install a trip bumper to each end of the pivot tube
and under the blade stop as shown below. The
round boss on the bumper will fit into the pivot
tube, and the long bumper leg will butt up against
the upward bend of the quadrant.
Trip Bumper
Trip
Bumper
1/2" x 3-11/16"
Clevis Pin
5/16" x 5"
Cap Screw
5/16" Locknut
Pivot
Tube
5/16" Washer
5/16" Washer
1/2" x 3-11/16"
Clevis Pin
Cotter
Pin
Cotter
Pin
Receivers
Hitch
Pin
Hitch
Pin
