16
6179-2201
\Vn – Single Line Connect Message Enable
This command enables or disables the single line connect message format as follows:
\V0 Connect messages are controlled by the command settings X, W, and S95.
\V1 Connect messages are displayed in the single line format described below subject
to the command settings V (Verbose) and Q (Quiet). In Non-Verbose mode (V0),
single line connect messages are disabled and a single numeric result code is gen-
erated for CONNECT DTE.
When single line connect messages are enabled, there are no CARRIER, PROTOCOL,
or COMPRESSION messages apart from the fields described below.
The single line connect message format is:
CONNECT
<DTE Speed></Modulation></Protocol></Compression></Line
Speed>/<Voice and Data>
Where:
<DTE Speed> = DTE speed, e.g., 57 600.
Modulation = “V90” for V.90 modulation.
“K56” for K56flex modulation.
“V34” for V.34 modulation.
“V32” for V.32 or V.32bis modulation.
Note: Modulation is omitted for all other modulations.
Protocol = “NONE” for no protocol.
“ALT” for Microcom Network Protocol.
“LAPM” for LAP-M protocol.
Compression = “CLASS5” for Microcom MNP5 compression.
“V42BIS” for V.42bis compression.
Note: Compression is omitted if protocol is NONE.
Line Speed = Asymmetric rates are displayed as /rate:TX/rate:RX, e.g., /1 200
TX/75 RX.
Symmetric rates are displayed as a single DCE rate, e.g., 14 400.
Voice and Data = Blank for Data mode only.
LAPM-SREJ = Selective reject.
