Section VE2-848-CK6-20A
030-101704 Rev. C
R
3
1006IARC
Figure 3. Mounting Views
19" Rack Mounting
23" Flush Rack Mounting
Wall Mounting
Attach short ear flange to rack channel
Attach panel to ears
D
D
Attach long ear flange to rack channel
D
Attach panel to ears
D
Attach ears to panel, as shown (flip brackets)
D
Mark and pre-drill mounting holes in wall (use keyhole-shaped holes)*
D
Attach panel to wall
D
Long
Flange
(use keyhole-shaped holes)
of Ear
Short
Flange
of Ear
* Can be mounted vertically, if desired.
** For a projected" appearance, bring or mount the panel further forward on the ears.
D-ring
(optional)
Panel mounts flush against front face of channel**
Lacer Bar Mounting
Attach mounting/panel to rack
Attach lacer bar to rack
D
D
Lacer bar*
#12-24 screw
*Alternate type shown
2.
Remove ears from bag.
Locate the bag of parts shipped
with the panel and remove the two L-shaped mounting
ears and the rack mounting hardware. Each ear flange has
several sets of mounting holes in it.
3.
Determine horizontal position (shelf projection).
The
mounting ears and the panel’s side flanges have several
mounting holes from which to choose, for the desired
amount of projection in the rack. If a
projected look
or ori-
entation in the rack is desired, the ears should be attached
in the last, rear-most, ear hole position on the panel’s side
flanges, so that the panel will be projected further forward
from the mounting ears. If a
flush look
in the rack is de-
sired, the mounting ears should be attached in the first or
forward-most ear hole position on the panel’s side flanges.
4.
Attach short flange of ear to panel.
Attach both ears to the
panel in the desired projection position as determined in
the step above, using the hardware provided. The ear’s
short flange abuts the panel.
5.
Attach panel to rack.
Lift the panel and attach it to the rack
channels in the correct vertical rack position. Align the
holes in the ear’s long flange with the proper holes in the
rack channels. Insert the provided screws into the aligned
set of holes, then tighten the screws. Repeat for both ears.
2.3
Mounting on a Wall
The mounting ears can be attached for wall mounting. Follow
local codes and company practices for the proper wall type.
1.
Determine position on wall.
Select the mounting location
on the approved wall. This panel requires one
vertical
Rack Unit (RU) in a standard Telco relay rack.
Note that the
panel can be mounted in a vertical position, if desired.
2.
Remove ears from bag.
Locate the bag of parts shipped
with the panel and remove the two L-shaped mounting
ears and the rack mounting hardware. Each ear flange has
several sets of mounting holes in it.
3.
Determine horizontal position (wall projection).
The
mounting ears and the panel’s side flanges have several
mounting holes from which to choose, for the desired
amount of projection from the wall. If a
more projected
position
on the wall is desired (allows greater rear access),
the ears should be attached in the last, rear-most, ear hole
position on the panel’s side flanges. If a
less projected posi-
tion
on the wall is desired (allows more front access), the
mounting ears should be attached in the first or forward-
most ear hole position on the panel’s side flanges.
4.
Attach ears to panel.
Attach both ears to the panel in the
desired projection position as determined in the step
above, using the hardware provided.
5.
Mark mounting hole locations.
Lift and place the panel on
the wall in the desired final position and mark the mount-
ing holes to be drilled in the wall with a marking utensil.
6.
Drill holes.
Set aside the panel and drill the holes. Do not
make the holes too big.
