Westell PROACT 3115-80, Manual

Page: 25 / 26

Section 311-580-20B
030-101527 Rev. B
25
0407IBRB
Table 12 - Continued. Appendix B - Remote Query and Response Codes
Query Function TL1 Command
(See Note 1)
TL1 Command
Response
16-Bit Command Code
(See Note 2)
Bit Error
Response
Setting/Parameter Default
CPE-to-FAC Path
Q WSTTRMTRGN DIS Regen Off
Query
WSTTRMTLBO 0 900 LBO 0dB
7.5 1070 LBO 7.5dB
15 1150 LBO 15dB
22.5 1220 LBO 22.5dB
AB15
1100 0100 1011 0000
1500 AB15
AB22.5
1100 0100 1011 0000
1600 AB22.5
WSTTRMTRGN ENA
(C4B0)
Regen On
WSTTRMTLBO 0 1900 LBO 0dB
7.5 2070 LBO 7.5dB
15 2150 LBO 15dB
22.5 2220 LBO 22.5dB
AB15 2500 AB15
AB22.5 2600 AB22.5
Function Code Sequence Hex
C d
Bit Error Responses and dB Levels q
Code
BER Level BER Level BER Level BER Level
CPE Level Query 1100 0101 0110 1110
Unframed, SF or ESF C56E 6
10
20
0 dB
-1 dB
-2 dB
60
70
80 -6 dB
-7 dB
-8dB
120
130
140 -12 dB
-13 dB
-14 dB 180
190
200 -18 dB
-19 dB
-20 dB
Facility Level Query 1100 0101 0110 1111
Unframed, SF or ESF C56F
20
40
30
50 -2 dB
-4 dB
-3 dB
-5 dB 80
90
100
110
-8dB
-9dB
-10 dB
-11 dB
140
160
150
170 -14 dB
-16 dB
-15 dB
-17 dB 200
400
410
-20 dB
-21 dB
Loss of signal
Note 1:
TL1 commands are transmitted in the Facility Data Link (FDL) using the command SND-CMD-FDL via the LAPB protocol. The command used to provision the unit is:
RTRV-T1:::<CTAG>:::OPTNM>-<OPTSTG>;. Example of the TL1 command to change the Application Mode of the unit is: RTRV-T1::::::WSTTXLBO=7.5; The unit then will respond
to the command with TL1 command in this example 7.5.
Note 2:
All 16-bit command codes must be sent to the unit for minimum of five seconds in order to provision the unit. In order to see a bit-error response from the unit, the command code
must be present for a minimum of 10 seconds. The unit will respond to the command with bit errors after the 10-second time frame.
Table 12.
Remote Query and Response Codes