Section 311-580-20B
030-101527 Rev. B
14
0407IBRB
Figure 13. A Directory Tree/Path of Software Menus Accessed Via the Craft Interface & VT100 Terminal
Main
Menu
Alarm
Thresholds
Provisioning
Circuit Status
(& Loopbacks)
Performance
Statistics
Set Clock
Main Menu Screen
on VT100 Terminal
Level 2 -
Level 1 -
Event/Alarm
Log
Reports
NotePad
Event/Alarm
Log Report
Provisioning
Report
Short PM
Report
Long PM
Report
Delete Record
15 Minute
Current
Hourly
Daily
Add Record
See Figure 14 through Figure 25
for sample menu screens.
Help
Change Circuit ID
Change Options
Test Mode
Provisioning
Submenus
Figure 14. Main Menu Screen
Westell B90-311580
CLEI: T1S1ABTAAA
MAIN MENU
PROACT
T1 PERFORMANCE MONITORING NIU
WESTELL TECHNOLOGIES, INC.
AURORA, IL.
1-800-323-6883
SELECTIONS
O) PROVISIONING
P)
PERFORMANCE STATISTICS
S)
CIRCUIT STATUS
L)
EVENT/ALARM LOG
C)
SET CLOCK
T)
ALARM THRESHOLDS
R)
REPORTS
N) NOTEPAD
?)
HELP
Enter letter of selection
tion can be changed to. Use <tab> or the arrow keys to advance
to an option field. Use the <space> bar to change the available
options under the NEW" field.
9.2.2.1
Saving The Changed Options
After configuring the options, press <S> to save the new set-
tings.
Note:
If you enter <Esc> without saving, the system will give
a message asking if you want to save the new settings.
- WARNING -
Always save changes before disconnecting to activate the changes. If
the craft terminal is disconnected without saving the changes, the
changes will be lost (unit does not save changes automatically).
9.2.3
PERFORMANCE STATISTICS Menu Screens
The Performance Statistics screens are used to view the stored
T1 performance statistics. To reach this screen from the MAIN
menu, type <P>. The example screen below (Figure 16), shows
various performance parameters for both the NET-to-CPE (A
to Z) and CPE-to-NET (Z to A) directions as well as a status reg-
ister describing abnormal circuit conditions during the period.
By using the selection keys at the bottom of the screen, all His-
torical time registers can be examined. Type the appropriate
command to view the 15-minute, Hourly, and Daily screens or
the <N> for Next and <P> for Previous page commands. The
parameters on these screens are automatically updated at 5-sec-
ond intervals. To return to the MAIN menu from this screen,
press the <Esc> key.
