Section BXB‐5VA‐20A
030‐101799 Rev. A
R
10
1307IARA
Figure 16. Optional BXA05V‐HP2 Battery Heater Pad
Heater Pad, cable side up
Pad
connector
cable
Right wall
Insert pad into battery box
is near the right
wall of the battery box
so that the cable
it from its protective wrapping. Note the special water
proof grommet and nut in the middle area of the cable.
2.
Remove knock‐out in main Boxer cabinet.
If not already re
moved, locate the main cabinet's bottom knock‐out that is
provided for the battery cable and remove the knock‐out.
3.
Remove nut from battery cable's middle grommet.
Un
screw and remove the lock nut from the threaded end of
the special grommet in the middle of the battery cable.
4.
Route power end of cable into the the main Boxer cabinet.
Starting inside the battery box, route the
Power
or
main
cabinet end
of the cable (with the E, F, G, and H power con
nectors) up through the previously removed grommet lock
nut installed in the knock‐out hole in the cabinet, and into
the main boxer cabinet. Pull the battery cable up until the
special grommet in the middle of the cable abuts the hole
edges and the threaded part protrudes into the main cabinet.
5.
Secure cable's middle grommet in the knock‐out hole.
Press and hold the cable's special grommet against the
knock‐out hole and screw the threaded lock nut back onto
the threaded part of the grommet. Fully tighten the nut.
6.
Install optional battery heater pad.
Install the optional
battery heater pad (Figure 16) at this time, if not previ
ously installed (see Paragraph 3.7.1). Verify the
cable/connector end of the pad faces right (closest to the
hole for the battery cable in the battery box ceiling).
7.
Connect heater pad to battery cable.
Locate the connector
at the end of the heater pad cable and connect it to Con
nector C of the battery cable.
8.
Connect AC plug to AC duplex outlet in main cabinet.
In
the main cabinet, insert the battery cable's AC plug (Con
nector E) into the AC duplex outlet at the bottom of the
cabinet.
9.
Connect temperature sensor probe connector to battery
charger.
Locate connector F of the battery cable and con
nect it to the appropriate connector of the battery charger
in the cabinet.
3.7.3
Pre‐installing the Battery Tie‐down Strap
Before placing the batteries in the battery box, first place,
fasten, or secure the provided battery strap to the rear wall tie‐
down railing. The strap may be passed through the length of the
rear wall railing, then the strap ends/connectors can be pulled
outside of the cabinet through the door, to be connected and
tightened after the batteries are installed.
3.7.4
Installing the Batteries
Before battery installation, first install the battery cable by per
forming the steps in Paragraph 3.7.2, and the optional heater
pad (see Paragraph 3.7.1 and Figure 16), then install the bat
Figure 17. Battery Cable
AC plug
DC Power, Red, Positive lead
(to +V on battery charger)
DC Power, Black, Negative
lead (to ‐V on battery charger)
Lock nut
Waterproof Grommet
(special plastic fitting
with threaded coupler)
Battery quick‐
disconnect
Temperature
sensor probe
connector
Battery heater
pad connector
Temperature sensor probe connector
Battery ring
connectors
A
B
C
D
E
F
G
H
main Boxer cabinet
Battery End of Cable
to
Battery Compartment
Power End of Cable
to
