Westar Udder Gun, Manual

Page: 8 / 52

8
Only knowledgeable, skilled personnel should perform the installation of the
Udder Gun System.
Plan Your Installation First
The four categories are:
1. Prep Station Location
2. Primary Hose Routing
3. Gun Zone and Connection Point
4. Flush Holster Location
1. Prep Station Location

Requires ample wall space for the unit to have daily access.
-
8” around all sides and 4' above floor is suggested.

Must never freeze.

Requires floor space nearby for a pre-dip chemical barrel.
-
chemical suction hose is only 6' long and needs to reach the bottom of the barrel.

Must consider primary hose routing.
-
Primary hoses need to reach from the prep station to the parlor.
-
See Primary Hose Routing

Must have dry compressed air supply, 90-100 psi at 16 cfm, ideally nearby.

Must have fresh water supply, 35-60 psi at 50̊-100̊ F, ideally nearby.
-
Do not need water if you are going to run RTU (ready to use) chemical.

Should be close to a floor drain or bucket for periodic chemical priming.
2. Primary Hose Routing

See Sample Primary Hose Layouts (Page 9)

Must never freeze.

Must not be kinked or walked on.

Must reach from the prep to the gun connection point.

Should be routed cleanly, connection points accessible, and tied or
supported every 5’.
50’ Primary Hose
25’ Primary Hose
Installation Planning
Prep Station