West Mountain Radio
Status LED, Low Voltage Disconnect (LVD)
& High Voltage Disconnect (HVD) Operation
When the RIGrunner 4007U is ON and the input voltage
is within the normal range the status LED will be GREEN.
If the input voltage is outside of the range, the LED
will change to RED and the Powerpole
®
outputs will be
switched OFF. When input voltage returns to the normal
range the LED will change to green and the outputs
enabled. When the RIGrunner 4007U is turned OFF the
LED will also be OFF.
External Sense Input
The external sense terminal is comprised of two pins on
the left side of the unit accessible through a “knockout”
panel. The terminal provides a sense input and +5VDC
through a 330 ohm resistor and is suitable for a variety of
mechanical and electrical interlock circuits.
With the RIGrunner facing you (Powerpole
®
at the
bottom) the orientation of the terminal is:
Top Pin: 5VDC
Bottom Pin: Sense Input
External voltage may be used for the sense input or you
can use the supplied 5VDC.
The included RED lockout jumper may be installed to
prevent the unit from being turned on.
USB Charging
The USB port may be used to provide power to USB
devices, such as phones and tablets. The USB port
follows both the USB Organization’s dedicated charge
port (DCP) specification and Apple’s unique charge port
- meaning both Apple or Android phones and tablets or
DCP devices may be charged.
The USB port contains a 5V regulator that can provide up
to 2A current. However, the USB DCP and Apple devices
are requested by the 4007U to limit their load currents;
Apple devices are limited to 1A and DCP devices are
limited to 1.5A.
Specifications
Overall Dimensions
(max., w/o cables)
0.9”H x 9.7”W x 3.2” D
Weight
12.75 oz.
Voltage Readout Accuracy +/- 2% +1 Count
Current Readout Accuracy Less than 5A: +/- 0.25A,
5A to 40A: +/- 1A
High Trip
15V Typical
Low Trip
11V Typical
Auto Re-Start
13V Typical
Switching time, High Trip
15 milliseconds
Switching Time, Low Trip
3.3 seconds
