INSTALLATION
Mounting Procedure
1 Determine where the speakers will be mounted. Make sure the area is large enough for the speaker
to mount evenly. Also ensure the mounting location is deep enough for the speaker to fit.
2. Refer to the specifications on page 5 to determine the proper diameter hole.
3. Use the speaker as a template to mark the locations for the mounting screws. Drill the holes with a
3/32" bit.
4. Be sure to observe proper polarity when connecting the wires. The speaker’s positive terminal is
indicated with a “+”.
5. Insert the speaker to the cutout and mount them using the supplied hardware.
SPECIFICATIONS
Features and Specifications
WM652 |
6.5" COAXIAL MARINE SPEAKER
• Magnetically shielded design
• Santoprene rubber surround
• UV impregnated ABS heat-resistant weatherproof grille
• One-piece cast ABS basket
• Recommended amplifier power - 10-65 watts RMS, 175 watts peak per speaker
• Requires 3.45" of mounting depth and 5.63" cutout
Sensitivity: 93dB
Frequency response: 65 Hz – 20 kHz
Tweeter: 19 mm silk dome
Woofer: 6.5" polypropylene cone - 11 oz. magnet with 2 layer voice coil
Impedance: 4 ohms nominal
Outside dimensions: 7.25"
MARINE SPEAKERS
1-800-BOATING
3
