.
6. Attach Mandrel Bottle (#95) to back of Riveter by pressing it firmly onto the
back of the tool. This is a pressure fitting, and does not screw on.
7. Cycle air through tool once air connection is hooked up to insure correct
alignment of jaws.
Operating Instructions
1.
Attach a ¼” NPT (Quick Connect Valve) to the Universal Valve (#39). Plug
air supply into Quick Connect Valve. Air supply should operate at no higher
than 100 PSI.
2. Press Lever #89 down (+) to start the vacuum system. Press Lever up (-) to
shut off vacuum system
3. Insert mandrel of rivet into Riveter. Rivet will be held in Riveter by air vacuum.
If rivet falls out of tool, vacuum is not strong enough. Amount of vacuum can
be adjusted via Regulator #83 located beside the Mandrel Bottle area. Turn
this screw counter-clockwise to increase vacuum, or clockwise to
decrease
vacuum. The longer the rivet, the stronger vacuum is needed to hold rivet in
place in tool.
4. Mandrel will be ejected into Mandrel Bottle once Trigger is released.
5. NEVER allow Mandrel Bottle to fill more than 1/3 full. Damage to Hydraulic
Plunger may occur. To empty Mandrel Bottle, turn knob at end of bottle to
reveal bottle opening. Shake mandrels out of hole. Once emptied, turn knob
until opening is closed and Mandrel Bottle is resealed.
#89
#83
Care and Maintenance
Regular service should be performed on this tool for best performance
and longer life of tool.
1. Empty Mandrel Bottle before it gets more than 1/3 full of mandrels.
Too many mandrels in collector can damage the Hydraulic Plunger
and/or cause a hazardous condition for the operator.
2. Insure that jaws are clean and free of metal shavings, dirt and oil. To
access Jaws, remove Nosepiece (#1) and Head (#2) from Riveter.
Jaws will be loose in narrow end of Head. Remove the 3 Jaw
pieces, clean serrations with a wire brush or steel wool to remove
debris. Once Jaws are clean, carefully reassemble by inserting 3
pieces of Jaws into narrow end of Head, with serrations of jaws
facing inward towards each other. Tighten Head (#2) onto tool.
Screw Nosepiece onto Riveter by turning clockwise. You will be
pushing the Jaws into the tool a
s you’re attaching Nosepiece;
securely tighten Nosepiece to Riveter with wrench.
3. Keep oil at optimum level. With use of tool there may be a gradual
loss of oil. When you notice a reduction in the stroke, you need to
add a small amount of oil.
-
Change nosepiece to largest diameter that the tool accepts.
This is necessary in order to test the tool after the oil has
been filled.
-
Remove air supply to Riveter, and remove Oil Plug (#17) on
top of Riveter using Allen wrench (included).
-
Use proper oil as listed under Specifications. Put small
amount of oil in a saucer or cup; place syringe nozzle
(syringe included) down into oil, then draw plunger of
syringe back to fill body of syringe.
-
Screw syringe nozzle into Riveter in top hole where Oil Plug
(#17) was removed. Very slowly push in plunger of syringe
to deliver oil into tool.
Remove Oil Plug
+
-
5/6
