7
9.
Make sure that all parts are properly tightened before you use the exercise cycle.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8. Identify the Left Pedal (10), which is marked with a
sticker. Using an adjustable spanner,
firmly tighten
the Left Pedal
counterclockwise
into the left arm of the
Crank (12). Tighten the Right Pedal (not shown)
clock-
wise
into the right arm of the Crank.
Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, the Pedals must
be kept tightened.
8
10
12
7
7. Attach the Handlebar (3) to the bracket on the Upright (2)
with the Handlebar Clamp (18), an M5 x 54mm Button
Screw (48), an M5 Curved Washer (49), and the
Adjustment Handle (17).
18
2
17
3
49
48
6. Have another person hold the Console (5) near the
Upright (2). Connect the console wire to the Upper
Wire Harness (56).
Insert the excess console wire and Upper Wire
Harness (56) down into the Upright (2). Attach the
Console (5) to the Upright with two M5 x 12mm
Screws (52).
Be careful to avoid pinching the wires.
5
6
Be careful to
avoid pinching
the wires.
2
52
56
Console
Wire
