ASSEMBLY
4
2
5
14
1
9
18
Square
Holes
2
Slot
1
32
2. Align the Front Stabilizer (5) with the saddle bracket
on the front of the Frame (1). Make sure that the
Front Stabilizer is turned so the square holes
are facing away from the saddle bracket. Attach
the Front Stabilizer with two M8 x 40mm Carriage
Bolts (18), two M8 Curved Washers (14), and two
M8 Nylon Locknuts (9).
3
40
1
32
Hole
38 9
41
55
55
42
42
3
50
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Assembly requires a phillips screwdriver
and an adjustable wrench (not included). A small amount of liquid soap is also required.
1. Refer to the inset drawing. Remove the Shipping
Insert (54) from the Frame (1) and discard it.
Turn the Rear Stabilizer (2) so that the slot is down,
and insert the Rear Stabilizer into the Frame (1).
Attach the Rear Stabilizer with four M5 x 10mm
Machine Screws (32).
3. Remove all parts from the Pivot Axle (3). Insert the
Pivot Axle into the Frame (1). Align the hole in the
center of the Pivot Axle with the hole in the center of
the Frame. Tighten an M5 x 10mm Machine Screw
(32) into the Frame and the Pivot Axle.
Slide the Left and Right Handlebars (40, 41) onto
the ends of the Pivot Axle (3). Slide an M8 Flat
Washer (38) onto each end of the Pivot Axle, and
then thread an M8 Nylon Locknut (9) onto each end
of the Pivot Axle. Tighten each Nylon Locknut until
at least two threads on the end of the Pivot Axle
extend past the Nylon Locknut. Make sure that the
Handlebars move freely.
Press a Pivot Endcap (50) onto each end of the
Pivot Axle (3).
Apply a small amount of liquid soap to the upper
end of each Handlebar (40, 41). Slide a Foam Grip
(42) onto each Handlebar. Make sure that there is
a Handlebar Endcap (55) in each Handlebar.
1
1
54
9
38
50
