5
2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (28) to the Frame with two
M10 x 72mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
34
28
1
2
33
33
3. The Console (23) requires three “AA” batteries (not
included); alkaline batteries are recommended. Insert
three batteries into the battery compartment. Make
sure that the batteries are oriented as shown by
the diagram inside the battery compartment.
23
Batteries
3
4. While another person holds the Console (23) near the
Upright (2), connect the console wire to the Upper
Wire (44). Next, attach the ground wire to the Upright
with an M4 x 16mm Screw (42). Insert the console
wire and the Upper Wire into the Upright, and insert
the ground wire into the Console.
Next, attach the Console (23) to the Upright (2) with
four M4 x 16mm Screws (42). Be careful to avoid
pinching the console wire, the ground wire, or the
Upper Wire (44).
Turn the Resistance Knob (63) counterclockwise to
the lowest setting before going to the next step.
4
23
2
44
63
Console Wire
Ground Wire
42
42
5
1
2
33
Make sure that
the wires and
cables do not
get pinched
and damaged
during this
step.
44
53
48
55
63
59
5. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the Reed
Switch Wire (53). Next, connect the Resistance Cable
(63) to the Lower Cable (55) in the following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (55), and insert the tip of the
Resistance Cable (63) into the wire clip inside of the
metal bracket.
• See drawing B. Firmly pull the Resistance Cable
(63) and slide it into the metal bracket on the Lower
Cable (55) as shown.
• See drawing C. Using pliers, squeeze together the
prongs on the upper end of the metal bracket.
Push the excess cable and wire down into the Frame
(1). Next, slide the Upright (2) onto the Frame. Be
careful not to pinch the wires or cables. Attach the
Upright with two M10 x 66mm Button Bolts (48), two
M10 Split Washers (59), and two M10 Nylon Locknuts
(33). Do not tighten the Button Bolts yet.
55
55
Metal
Bracket
B
A
C
55
63
63
63
