9.
Make sure that all parts are properly tightened before
you use the treadmill.
Keep the included allen wrench
in a secure place. The allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet,
place a mat under the treadmill.
8. Carefully lower the Handrails (6, 7) to the floor. Center the
Frame (55) between the Handrails, and tighten the four
Handrail Bolts (12). Then, raise the Handrails to the verti-
cal position.
See drawing 8a. Attach the Latch Assembly (41) to the
Left Handrail (7) with two 16mm Screws (58).
Make sure
that the Latch Assembly is oriented as shown.
Insert the Incline Pins at the desired incline level (see
HOW TO CHANGE THE INCLINE OF THE TREADMILL on
page 11
).
41
7
58
7. Attach the Console Back (4) to the Console (1) with four
16mm Screws (58). There is a slot in the side of the
Console Back for the wire.
Make sure that no wires are
pinched.
1
58
4
58
58
Slot
6. Set the Console (1) on the Right Handrail (6) and the Left
Handrail (not shown). Start four Console Screws (70)
(only two are shown) into the Console.
After you have
started all four Console Screws, tighten them.
Insert the excess Wire Harness (22) down into the Right
Handrail (6). Tighten the three plastic ties around the Wire
Harness, and then cut off the ends of the plastic ties.
22
Plastic
Ties
1
6
70
6
7
8
8a
6, 7
55
12
8
