Weslo EasyFit WLIVEL0063.1, User Manual

Page: 8 / 16

6
CONSOLE FEATURES
Follow your progress with the display.
The console has sIX displays that show the
following workout information:
Speed—This display shows your pedaling speed,
in revolutions per minute (rpm).
Time—This display shows the elapsed time.
Note: When a smart program is selected, the display
will show the time remaining in the program
instead of the elapsed time.
Distance—This display shows the distance you
have pedaled, in total revolutions.
Calories—This display shows the approximate
number of calories you have burned.
Pulse—This display shows your heart rate when
you use the handgrip pulse sensor.
Scan—When you select this display option, the
upper section of the display will show both time
and distance information, and the lower left section
of the display will show calories and fat
calories information.
Target Heart Rate [T.H.R.]—This display the target
heart rate you’ve chosen.
HOW TO USE THE CONSOLE
Make sure that the console has batteries (see page
MAINTENANCE AND TROUBLESHOOTING). If
there is a sheet of clear plastic on the face of the
console, remove it.
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2. Press the buttons :
MODE :
Press this button to switch the display between the
values. If you press this button for more than four
seconds, all values will be reset.
2. UP/ DOWN :
Press this button to enter the target values.
3. RECOVERY :
Press this button to use the Pulse recovery test (see
below for more information).
3. Start pedaling and follow your progress with
the display :
While you exercise, the console will display the
selected mode.
4. When you are finished exercising, the console
will automatically turn off.
If the pedals do not move for a few seconds, the
word STOP will appear in the display, and the
console will pause. The console has an “auto-
off” feature. If the pedals do not move and the
console buttons are not pressed for a few minutes,
the power will turn off automatically to save the
batteries.
How to use the Pulse Recovery Test :
It is a function to check the condition of pulse
recovery that is scaled from 1.0 to 6.0 while 1.0
means the best and 6.0 means the worst and the
increment is 0.1. In order to get rated correctly,
users must test it right after the workout finished by
pressing “TEST(RECOVERY) ” key and then stop
exercising. After the key is pressed, please also
apply the heart rate detector appropriately, the test
will last for 1 minute and the result will show in the
display. If the computer does not detect your current
heart rate, pressing “TEST(RECOVERY) ” will not
enter into pulse recovery test. During the pulse
recovery test, press “TEST(RECOVERY) ” to exit
the test and return to the stop status.
CONSOLE FEATURES