14
SPA JET UNIT OPERATION
The spa jet unit features five hydro-therapy jets, a
whirlpool diverter, a suction vent, and a filter housing.
The
five hydro-therapy jets
(A), located on the front
of the spa jet unit, focus the water massage on your
neck and back.
The
whirlpool diverter
(B), located on the left side of
the spa jet unit, directs the flow of the water to create
a whirlpool action in the DAYBREAK.
The
suction vent
(C),
located on the right
side of the spa jet
unit, pulls the water
into the spa unit, in
order to operate the
system. The suction
cover should always
be in place over the
suction vent.
Never
operate the DAY-
BREAK without the
suction cover in
place.
The
filter
(D), is locat-
ed on the left side of
the spa jet unit,
behind the Filter
Cover (47). The filter
can be removed for
cleaning and replace-
ment by removing the
Filter Cover and the
two Filter Cover Screws (57) and then pulling the filter
from the spa jet unit.
The spa jet unit features an automatic filter cycle and
freeze protection. If the spa jet unit has not been
operated for three hours, the pump will begin circulat-
ing the water for twenty minutes to filter any impuri-
ties. Also, if the water temperature falls below 40¡F,
the pump will begin circulating and heating the water
to prevent the water from freezing.
DRAINING THE DAYBREAK
To drain the DAYBREAK, you must use a garden
hose to siphon the water. Place one end of the hose
in the DAYBREAK and hold it in front of a hydro-ther-
apy jet until there is a flow of water coming out of the
hose.
Turn off the spa unit and unplug the power
cord. The unit will be damaged if it is run without
water circulating.
Be sure the end of the hose in the
DAYBREAK is on the floor of the spa.
DRAINING THE PUMP
After the DAYBREAK
is drained (see
DRAINING THE DAY-
BREAK above), the
pump in the spa jet
unit should also be
drained if the DAY-
BREAK will be stored
for more than thirty
days, or if it may be
exposed to freezing temperatures.
To drain the pump, remove the spa jet unit from the
side panels.
Be careful not to tear the spa liner.
Locate the pump inside the spa jet unit. Remove the
indicated bolt from the pump. Tip the spa jet unit
slightly, until all the water has drained from the pump.
Replace the drain plug.
A
B
D
C
C
Drain Plug
Pump
D
47
57
