9
9
16
8. While another person holds the Upright (13) in
the position shown, connect the Extension Wire
(52) to the Reed Switch Wire (43).
Next, connect the Resistance Cable (19) to the
Lower Cable (45) in the following way:
•
See drawing A
. Pull upward on the metal
bracket on the Lower Cable (45), and insert
the tip of the Resistance Cable (19) into the
wire clip inside the metal bracket as shown.
•
See drawing B.
Firmly pull the Resistance
Cable (19) upward and slide it into the top of
the metal bracket as shown.
•
See drawing C.
Using pliers, squeeze the
prongs on the upper end of the metal bracket
together.
Push the excess wire and cable downward into
the Frame (1), and insert the Upright (13) into the
Frame.
Be careful to avoid pinching the
wires and cables.
Attach the Upright to the
Frame with three M8 x 20mm Button Screws
(34) and three M8 Split Washers (42).
A
B
C
45
19
19
Metal
Bracket
Metal
Bracket
45
1
13
45
19
52
Batteries
Battery
Cover
34
34
42
42
8
9. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
Remove the battery cover and insert four batter-
ies into the Console as shown.
Make sure that
the batteries are oriented as shown by the
diagram inside the Console.
Then, reattach
the battery cover.
43