5
5. The Electronic Monitor (19) requires two ÒAAÓ batteries (not includ-
ed). Alkaline batteries are recommended. Open the battery cover on
the back of the Monitor. Insert two batteries into the Monitor.
Make
sure that the negative ends of the batteries (marked ÒÐÓ) are
touching the springs in the Monitor.
Close the battery cover.
6. Connect the Sensor Wire (47) into the wire extending from the
Electronic Monitor (19). Slide the Electronic Monitor onto the bracket
on the Frame (46). Make sure that the Sensor Wire is not pinched
between the Monitor and the Frame.
7. This step may have been completed. If not, please apply a small
amount of grease to the bolt welded in the Right Handlebar (38).
Connect a Link Arm (26) to the lower end of the Right Handlebar (38)
with a Brass Handlebar Bushing (27), an M8 Zinc Washer (43), and
an 8mm Zinc Locknut (36) as shown.
Attach the other Link Arm to the Left Handlebar in the same manner
(not shown).
47
46
26
36
43
27
38
19
8. Note: Apply a small amount of
grease to all of the small parts
assembled in this step. Slide a
13mm Washer (23) onto the
indicated end of a Pedal Axle
(24). Insert the Pedal Axle into
the right Link Arm (26). Slide a
Steel Link Arm Bushing (32), a
13mm Washer (23), and a
Pedal Spacer (33) onto the
Pedal Axle. Firmly tighten the Pedal Axle clockwise into the right arm of the Crank (39). Tighten a 1/2Ó
Locknut (22) onto the Pedal Axle.
Attach the other Pedal to the left arm of the Crank (not shown) in the same manner.
9.
Make sure that all parts of the exercise bike are properly tightened.
5
6
7
Batteries
Cover
19
11
24
23
26
32 23
33
39
22
8