6
7
5
4
1
21
7. Attach the Right Handlebar (4) to the Upright
(1) with two M6 x 12mm Button Head Bolts
(21).
Attach the Left Handlebar (5) to the Upright (1)
in the same manner.
8. Refer to the inset drawing. The Console (10)
requires two ÒAAÓ batteries (not included).
Alkaline batteries are recommended. Press two
batteries into the battery clip under the Console.
Make sure that the negative (Ð) ends of the
batteries are touching the springs.
Connect the Reed Switch Wire (12) to the
Console (10).
Attach the Console (10) to the Upright (1) with
four M4 x 16mm Console Screws (22).
Be care-
ful to avoid pinching the Reed Switch Wire
(12).
9.
Make sure that all parts are properly tight-
ened before you use the stepper.
10
Batteries
8
10
12
1
22
6. Apply grease to the shafts on the Upright (1).
Slide a Cylinder Spacer (19) and a Resistance
Cylinder (9) onto each of the shafts on the
Upright (1).
Make sure that the indented
sides of the Cylinder Spacers are facing the
Upright.
Tap a 5/8Ó Axle Cap (18) onto each
shaft.
Raise the Left Pedal Leg (6) and rest it on the
hook at the lower end of the left Resistance
Cylinder (9). The hook must be in one of the
slots under the Left Pedal Leg as shown in the
inset drawing.
Raise the Right Pedal Leg (7) and rest it on the
hook at the lower end of the right Resistance
Cylinder (9).
Make sure that the hooks are in
the same position under both Pedals.
6
19
19
1
18
18
9
7
9
Slots
6
Apply
Grease
