Wesco WS8043, Instruction Manual, Page: 11 / 16

11
EN
PRODUCT SAFETY
GENERAL SAFETY
WARNINGS
WARNING: Read all safety warnings
and all instructions.
Failure to follow the
warnings and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future
reference.
- This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for
their safety.
- Children should be supervised to ensure that they do not
play with the appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
WARNING: To reduce the risk of injury,
user must read and understand
instruction manual.
1) Training
a) Read the instructions carefully. Be familiar with the
controls and the proper use of the appliance;
b) Never allow people unfamiliar with these instructions
to use the appliance. Local regulations may restrict the
age of the operator;
c) Never operate the appliance while people, especially
children, or pets are nearby;
d) The operator or user is responsible for accidents or
hazards occurring to other people or their property.
2) Preparation
a) While operating the appliance, always wear substantial
footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals;
b) Do not wear loose clothing or jewellery that can be
drawn into the air inlet. Keep long hair away from the
air inlets.
c) Wear protective goggles while operating
d) To prevent dust irritation the wearing of a face mask is
recommended
e) Before using, check the supply and extension cord for
signs of damage and aging. Do not use the appliance if
the cord is damaged or worn.
f) Never operate the appliance with defective guards or
shields, or without safety devices,
g) Only use a weather proof extension cable fitted with a
coupler according to IEC 60320-2-3.
h) The appliance should being supplied via a residual
current device (RCD) with a tripping current of not
more than 30 mA is recommended.
i) I f an extension cord is used make sure it is for outdoor
use and marked as such. The recommended size of
extension cord is not lighter than 1 mm
2
.
3) Operation
a) Always direct the cable to the rear away from the
appliance.
b) If the cord becomes damaged during use, disconnect
the supply cord from the mains immediately. DO NOT
TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY.
c) Do not carry the appliance by the cable.
d) Disconnect the appliance from the mains supply
- whenever you leave the machine;
- before clearing a blockage;
- before checking, cleaning or working on the
appliance;
- if the appliance starts to vibrate abnormally.
e) Operate the appliance only in daylight or in good
artificial light.
f) Do not overreach and keep your balance at all times.
g) Always be sure of your footing on slopes.
h) Walk, never run;
i) Keep all cooling air inlets clear of debris.
j) Never blow debris in the direction of bystanders.
k) Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times;
l) Never pick up or carry the appliance while the engine is
running;
4) Maintenance and storage
a) Keep all nuts, bolts and screws tight to be sure the
appliance is in safe working condition;
b) Replace worn or damaged parts.
c) Use only genuine replacement parts and accessories.
d) Store the appliance only in a dry place.