18
EN
TROUBLESHOOTING
Symptom
Possible Cause
Remedy
Chainsaw fails to
operate.
Low battery charge.
Chain brake not in the proper
position.
Charge both the battery packs.
Check to see if the chain brake is in
position 1 . Refer to THE CHAIN
BRAKE section for details.
Chainsaw
operates
intermittently.
Over heating.
Applying too much pressure while
cutting
Loose connection.
Internal wiring defective.
On/Off switch defective.
Place the machine in a cool,
ventilated place to cool it down.
Applying relatively less pressure
while cutting.
contact customer service center.
contact customer service center.
contact customer service center.
Dry chain.
No oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Refill oil.
Clean cap.
Clean oil passage outlet.
Brake does not stop chain
Run-down kickback brake.
contact customer service center.
Chain/chain bar
over-heats.
o oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Chain is over tensioned.
Dull chain.
Refill oil.
Clean cap.
Clean oil passage outlet.
Adjust chain tension.
Sharpen chain or replace.
Chainsaw rips,
vibrates, does not
saw properly.
Chain tension too loose.
Dull chain.
Chain worn out.
Chain teeth are facing in the wrong
direction.
Adjust chain tension.
Sharpen chain or replace.
Replace chain.
Reassemble with chain in correct
direction.
WARNING: Switch off and remove the battery pack before investigating fault.
Summary of Contents for CCS36WT
