Linking compressors
To link two compressors to work in stereo mode you need special Jack-Jack cable.
You can purchase it at WesAudio or you can do it yourself as it is shown below:
Zero Set
The 1176LN meter may occasionally need to be calibrated. This is accomplished by adjusting the
Zero Set potentiometer, located through a small hole on the front panel between the Input and Output
Cut if hum appear
Link connection
M
AINTENANCE
6
W
es
A
udio
It is recommended to switch on device at least 5 min before operating to ensures best parameters.
NOTE!
The device should be connected only to a ground outlet and proper voltage
Always replace the fuse with the type and value recommended by manufacturer.
230V - IEC 127 20x5mm T315mA
115V - IEC 127 20x5mm T630mA
Warning! High voltage inside ! To reduce the risk of electrical shock do not open the unit.
Installation
The procedure for adjusting the meter is as follows:
1. Power on the beta76 and wait 15min.
2. Press the Meter GR pushbutton.
3. Set the Input control fully off (turn the knob fully counterclockwise).
4. Use a small screwdriver to slowly adjust the Zero Set potentiometer so that the meter reads 0 dB.
Watch how the meter settles before completing the calibration.
