Page 2 of 2
3/8" Drive Ratchet
3/8" Drive Socket 1/2" Deep Well
TOOLS REQUIRED
PART IDENTIFICATION
Part Y (Qty. 2)
Universal Quick Clamp
INSTALLATION
ONLY OPERATE VEHICLE WITH
REAR CROSS MEMBER IN PLACE
DO NOT OPERATE VEHICLE WITH
REAR CROSS MEMBER REMOVED
IMPORTANT!
STEP ONE
STEP TWO
Clamps are spring loaded.
Always wear protective eye wear.
CAUTION
Remove the four 5/16 X 3" carriage
bolts from both the driver side and
passenger side triangle clamps hold-
ing the rear cross member in place.
NOTE:
Clamps are spring loaded.
Use caution when removing.
Set quick clamp, Part
Y, to represent picture
below by turning the
back plate180 degrees
from the front plate.
Insert quick
clamp at an
angle on tri-
angle bracket.
Turn back
plate 180 de-
grees.
Set cross
member onto
quick clamp
and tighten
Back
Plate
Quick clamps must be tight before
operating vehicle.
CAUTION
Triangle
Clamps
Triangle
Clamps
Triangle
Bracket
Part No. 24-0159
REV. B
ECN 5315 05/13
