30
BoSS X-Series
Maintenance Manual
Section 12 - Machine labelling
TO LOWER THE PLATFORM
WITHOUT POWER IN AN
EMERGENCY
1
TURN THE VALVE TO THE RIGHT
OF THIS LABEL ANTICLOCKWISE
UNTIL IT WILL NOT TURN ANY
FURTHER
2
PULL THE PRESSURE LOSS VALVE
RELEASE HANDLE TOWARDS YOU
UNTIL THE PLATFORM HAS FULLY
LOWERED AND THEN RELEASE
DO NOT USE A PRESSURE WASHER ON
THIS SIDE OF THE BASE UNIT UNLESS
BOTH RUBBER PLUGS ARE IN POSITION.
PRIOR TO THE RESTORATION OF POWER
TURN THE VALVE TO THE RIGHT OF THIS LABEL
CLOCKWISE UNTIL FULLY TIGHT AND THEN USE
THE HANDSET CONTROLLER IN ACCORDANCE
WITH THE INSTRUCTIONS FOR USE
1
4
6
9
10
11
12
13
14
2
3
4
5
7
9
10
11
12
13
16
15
8
Battery Charge
level indiCator
:
led displays
Battery Charge
level
WARNING: IF LIFT MOTOR FAILS TO
SHUTDOWN
OPEN THE DRAWER AT THE OPPOSITE SIDE OF
THE CHASSIS AND REMOVE 100 AMP FUSE USING
RED STRAP
BEFORE
UNDERTAKING TWO STAGE
EMERGENCY DESCENT PROCEDURE.
THEN, ARRANGE FOR REPAIR OF MACHINE BY
TRAINED ENGINEER.
PN117725 BoSS X3X_safety label_280x200mm_RevA 1218_PROOF 2_PRINT.pdf 1 17/12/2018 14:09
Charger
indiCator Lights
aC
Power
suPPLy
Charge
to 80% of
battery
CaPaCity
Charge
remaining
20% of
battery
CaPaCity
Charging
indiCator
OVERLOAD
Fork LiFting
Point
Pass transit
straPs
through here
MaxiMuM
WheeL
Load
450kg
InstructIons
for use
MAXIMUM SAFE WORKING LOAD 240KG –
ONE PERSON PLUS TOOLS AND MATERIALS
ATTENTION
PRESS THE EMERGENCY STOP BUTTON
ON THE HANDSET AND REMOVE THE
KEY PRIOR TO CHARGING .
POWER SUPPLY
:
110 OR 240 VOLTS .
!
SELECT THE APPROPRIATE CABLE
FROM THE CHARGING CABLES AND
GUARDRAIL TOOL BOX MOUNTED ON
THE GUARDRAIL AND PLUG IN BELOW .
PRESSURE LOSS VALVE RELEASE
IN THE EVENT OF A LOSS OF
POWER OR HYDRAULIC PRESSURE
PULL THE HANDLE TOWARDS YOU
UNTIL THE PLATFORM HAS FULLY
LOWERED AND RELEASE
TilT sensor zero calibraTion poinTs
Calibration
must
only be carried
out by fully trained maintenance
personnel.
HARNESS
LANYARD
POINT
ENSURE BOTH MAINTENANCE PROPS ARE IN POSITION BEFORE
UNDERTAKING MAINTENANCE UNDER THE RAISED PLATFORM.
CHARGING CABLES &
GUARDRAIL TOOLS
6
1
17
18
14
WARNING
If label number 7 (left) is not
visible on the outer face of
the toeboard of any of the
4 sides of the machine, DO
NOT USE the machine and
contact the manufacturer .
7
8
15
17
16
PN117724 BoSS X3_safety label_280x200mm_RevA 1218_PROOF 2_PRINT.pdf 1 17/12/2018 14:08
Please note the correct positioning of the decals and machine plate for
BoSS X-Series machines.
3
5
2
18
19
BOSS X-SERIES Machine Plate 164x73mm Rev 1118_PROOF 5_PRINT.pdf 1 12/11/2018 09:48
19
BoSS X Series_Maintanence Manual Rev B 0519.indd 30
16/05/2019 14:59
