Initialization
When there is change of
camera
, extreme changes in temperature, or instability during operation, you me
need to reset your SP1 and carry out the initialization process. Initialization is NOT require during the day
to day use except the above cases is encountered.
Procedures for Initialization / Reset
1
．
Follow the step in page 7 to install and Pre-balance properly.
2
．
Place GP1+ on a flat and stationary surface, and expose the power button as in Fig. 6-1.
Remarks: GoPro lens facing upwards.
3
．
Press the power button (Fig. 6-2), and the LED light will start to flash. At this moment, GP1 Plus will
automatically detect the environmental data such as temperature, magnetic field and humidity.
4
．
After the flashing stage, LED will remain long lit for 2 seconds. As soon as the LED turns to a flashing stage,
immediately hold the handle upright on the flat surface, at the same time holding the camera upright using the
other hand. Then release the hand that holds the camera after 1 second (Fig. 6-3).
5
．
At this stage, the LED will turn to long lit mode, and the angle adjustment process will begin. 6
．
After the
adjustment process, the LED will change to slow flashing mode (standby mode).
7
．
You may power off and then power on the device to begin normal operation.
Fig
6-1
Fig
6-3
Fig
6-2
014
