Wenglor weCat3D MLSL1x1, Operating Instructions Manual

Page: 35 / 59

35 2D-/3D Profile Sensors
5.5 Default Settings
WeCat3D MLSL WeCat3D MLWL
Pin function E/A1 Encoder E1+E2 Encoder E1+E2
E/A2 Encoder E1+E2 Encoder E1+E2
E/A3 Sync Out Sync Out
E/A4 Sync In Sync In
I/O settings E/A1 Operating voltage active Operating voltage active
E/A2 Operating voltage active Operating voltage active
E/A3 Push-Pull Push-Pull
E/A4 Operating voltage active Operating voltage active
Encoder Direction of rotation Independent of direction Independent of direction
Encoder scaling 0 0
Display Intensity Screensaver Screensaver
Mode Analysis Analysis
Operating mode Profile Sensor Profile Sensor
Profile Measuring rate (Hz) 200 175
Signal selection Strength Strength
Exposure time (µs)* 150 150
Field of vision (pix) Offset X 0 0
Width X 1280 2048
Offset Z 0 0
Height Z 1024 2048
Interface IP address 192.168.100.1 192.168.100.1
Subnet mask 255.255.255.0 255.255.255.0
TCP port 32001 32001
Std. gateway 192.168.100.254 192.168.100.254
MAC address See OLED display,
interface section See OLED display,
interface section
Language English English
Password OLED Deactivate/
activate Deactivated Deactivated
Change „0000“ „0000“
Website
password admin admin
* A standard exposure time is set upon shipment from the factory. With some surfaces, exposure time has to
be matched to ambient conditions, i.e. increased or reduced.