Safety Light Curtain
113
7.2.4 Installation with Mounting Bracket ZEMX001
Figure 33: Installation with ZEMX001
7.2.5 Warning Strips
• Both the emitter and the receiver of the ESPE have a yellow warning strip in a side groove on both sides.
• If mounting is to take place over the side groove (see
Section 7.2.2, page 112, Section 7.2.3, page 112,
), the warning strip must be removed at the relevant point.
• Please proceed as follows to remove the warning strip:
– Position a small screwdriver at the end of the warning strip and lever it carefully out of the groove.
– When removing, ensure that no components of the ESPE are damaged to guarantee correct function.
– To mount the warning strip, position it on the bottom end of the groove and click it in until it has engaged
over the entire length of the safety field.
• During this process, ensure that the profile, control panel, indicator lamp or glass are not damaged me-
chanically.
Figure 34: Yellow warning strip
