7
Lock Units Together
1. Before you lock any units together, set up all units and move them into position next to each other.
To move a 3-step riser, lift the 1st step and roll the unit on its two positioning wheels.
With 3-step risers, also attach any back rails and 4th-step options (see pages 10-11).
2. Lift one riser, and place it over the unit-to-unit clamp on a second unit.
If the riser hangs up on the clamp, loosen the clamp's two capscrews. Adjust to fit, and re-tighten the
capscrews.
1. Take off the first and third steps by loosening the
capscrews that hold the steps to the legs.
Don't loosen the second steps capscrews yet.
2. Turn the first and third steps end-for-end, and
switch their places as shown.
Reattach the steps to the legs.
3. Remove the second step, turn it end-for-end, and
reattach it to the legs.
4. Be sure all capscrews are tightened securely.
5. Remove the unit-to-unit clamps, and reattach them
at the opposite end of the steps.
6. If a back rail is used on a reversed riser, reverse the rail loop also.
To do this, depress the two snaps, separate the loop, turn the rail around, and snap it back together
(see page 11).
Reverse Step Arrangement
