21
20
MAINTENANCE
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of these
following conditions exist, do not use until parts are replaced or the
sharpener is properly repaired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
WARNING:
Any attempt to repair or replace electrical parts on this tool may be hazardous. Servicing
of the tool must be performed by a qualified technician. When servicing, use only identical WEN replacement
parts. Use of other parts may be hazardous or induce product failure.
CAUTION
:
Most plastics are suscep-
tible to damage from various types
of commercial solvents. Do not use
any solvents or cleaning products
that could damage the plastic parts.
Some of these include but are not
limited to: gasoline, carbon tetra-
chloride, chlorinated cleaning sol-
vents, and household detergents
that contain ammonia.
WARNING:
To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning,
adjusting, or performing any maintenance work.
CLEANING & STORAGE
1. Keep the ventilation openings free from dust and debris to prevent
the motor from overheating.
2. Wipe the tool surfaces clean with a clean cloth. Make sure water does
not get into the tool.
3. Store the tool in a clean and dry place away from the reach of chil-
dren. Store in temperatures between 41° to 86°F.
4. Cover the miter saw in order to protect it from dust and moisture. It is preferable to store it in its original pack-
aging with the instruction manual.
CARBON BRUSH REPLACEMENT
Replacement carbon brushes (Part No. MM1214-114) can be ordered at wenproducts.com. Only genuine WEN
replacement brushes designed specifically for your tool should be used.
1. To access the carbon brushes, remove the carbon brush cap (Fig. 26) with a flat-head screwdriver (not included).
2. Carefully remove the old carbon brushes using pliers.
3. Install the new carbon brushes. Both carbon brushes should be replaced at the same time. Replace the carbon
brush cap.
NOTE:
New carbon brushes tend to spark for a few minutes during the first use as they wear down.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains electronic
components that should be recycled. Please take this product to your local recycling facility for responsible dis-
posal and to minimize its environmental impact.
Fig. 26
Summary of Contents for MM1214
Page 28: ...THANKS FOR REMEMBERING ...