15
GENERATOR PREPARATION
ENGINE SWITCH
RUN
STOP
ON
OFF
OVERLOAD RESET
OUTPUT • OVERLOAD • OIL
DC 5V USB
1A
2.1A
AC 120V
NEMA 5-20R
NEMA L5-30R
AC 120V
ON
OFF
CIRCUIT BREAKER
CHOKE
PARALLEL
CONNECT
GROUND
ECO-MODE
Grounding
Nut
Fig. 8
TO ADD GASOLINE:
1. Place the generator on a level surface. Make sure the
engine is OFF before adding or checking the fuel.
2. Unscrew the fuel cap (Fig. 7) and set it aside. The fuel
cap may be tight and hard to unscrew.
3. Slowly add unleaded gasoline to the fuel tank. Be careful
not to overfill. Reinstall fuel cap and wipe clean any spilled
gasoline with a dry cloth.
NOTE:
Do not fill the fuel tank to the very top. If you do
so, gasoline will expand and spill during use, even with
the fuel cap in place.
TO CHECK GAS LEVEL
(before every subsequent start):
1. Before starting the generator, check the fuel gauge (Fig.
7) to see if there is sufficient fuel inside the tank:
•
E
= Empty
•
F
= Full
2. If the tank is empty add gasoline to the gas tank. See
above section, "To Add Gasoline".
STEP 3 - GROUND THE GENERATOR
To reduce the risk of electric shock and to maximize safety,
the generator should be properly grounded.
1. Attach one end of the grounding wire to the grounding
nut (Fig. 8). Tighten the nut to secure the grounding wire.
2. Connect the other end of the grounding wire to a copper,
brass, or steel-grounding rod that is driven into the earth.
Fuel Gauge
Fig. 7
Fuel Cap
WARNING!
Failure to properly ground the
generator increases your risk of electric shock.
NOTE:
Grounding wire and grounding rods
are not included with the generator. A general-
ly acceptable grounding wire is a
No. 12 AWG
(American Wire Gauge) stranded copper wire
.
Grounding codes can vary by location. Contact a
local electrician to check the area codes.
Summary of Contents for GN400i
Page 39: ...39 NOTES...