Wen DF475X, Instruction Manual

Page: 13 / 44

TO INSTALL THE FEET:
Slide two M6x40 bolts (32) through the foot support assembly (43) and the generator frame. Tighten with M6 nuts
(45). Repeat for the other foot.
TO INSTALL THE WHEELS:
NOTE: Connecting/disconnecting the battery’s negative terminal requires removing the right wheel. For your
convenience, the battery’s negative terminal has been pre-connected. Before installing the wheels, verify that the
negative terminal of the battery has been connected securely (see p. 18 for more information).
Slide the wheel axle (48) through the wheel (42), flat washer (16), and wheel bracket on the frame. Insert a cotter
pin (25) through the hole on the end of the axle to keep the wheel in place. Repeat for the other wheel.
TO INSTALL THE HANDLE:
Slide the M8x35 bolts (31) through the handle connector (49) and the frame. Tighten with the M8 nuts (64). Slide
the handle bolt (59) through the handle connector (49) and the handle (19), and tighten with M8 nut (64).
Next, install the handle fixing clip (30). Insert the M6x55 bolt (15) through the frame and handle fixing clip (30) and
tighten with M6 nut (45).
NOTE: Only the generator frame is shown to maximize clarity for assembly.
ASSEMBLY & ADJUSTMENTS
Fig. 1
13