![background image](http://html1.mh-extra.com/html/wen/df472x/df472x_instruction-manual_956396019.webp)
BEFORE STARTING THE GENERATOR
1. Verify that the generator is outside on a dry, level sur-
face. Allow at least two feet of clearance on all sides of the
generator.
2. To maximize safety, check that the generator is properly
grounded (see “Ground the Generator”).
3. Check there is sufficient level of oil in the crankcase. Add
oil if necessary (see “Add/check Oil”).
4. Verify the fuel selection dial is turned to the desired fuel.
Turn the dial up to the 12 o’clock position for gasoline and
down to the 6 o’clock position for LPG. Check that there is
adequate supply of the selected fuel.
5. Make sure all electrical devices are unplugged from the
generator during ignition. Otherwise it will be difficult for
the engine to start.
7. Allow the engine to run for several minutes before attempting to connect any electrical devices. This allows the
generator to stabilize its speed and temperature. Follow the instructions in the next section for properly connecting
your electrical devices.
NOTE:
In case you have had repeated failed attempts to start the engine, please consult the troubleshooting guide
before attempting to start the generator. If problems persist please call
1-(800) 232-1195
, M-F 8-5 CST.
a. To start the engine with gasoline:
3. Flip the engine switch to the ON position.
4. Move the choke lever to the OPEN/RUN position.
5. Pull the recoil starter to start the engine.
b. To start the engine with LPG:
3. Flip the engine switch to the ON position.
4. Pull the recoil starter 1-3 times to prime the engine.
Never allow the cord to snap back.
NOTE:
This is only
necessary when using LPG to start the engine.
5. Move the choke lever to the OPEN/RUN position.
6. Pulll the recoil starter to start the engine.
STARTING YOUR GENERATOR
WARNING!
The LPG cylinder valve must be shut
OFF when using gasoline. The generator’s fuel valve
must be shut OFF when using LPG.
Fig. 11
Fig. 12
STARTING THE GENERATOR
1. To use gasoline, turn the fuel valve to the ON position (Fig. 11). To use LPG, make sure all of the LPG connectors
and hoses are well connected and sealed. Close the fuel valve, then open the LPG tank valve.
2. Move the choke lever (Fig. 12 - 1) to the CLOSE/START position.
1
19
Summary of Contents for DF472X
Page 33: ...WIRING DIAGRAM 33...
Page 34: ...EXPLODED VIEW PARTS LIST GENERATOR 34...