Assembly
WARNING:
Read and understand
the safety chapter before you
assemble the product.
To assemble the guide bar and saw
chain
12
1. Install bumper spike.
2. Remove the guide bar nuts and the clutch
cover. Remove the bolt protection.
3. Put the guide bar above the bar bolts.
4. Put on protective chainsaw gloves.
5. Lift the saw chain above the drive sprocket
Bumper spike
Bolt protection
Guide-bar nuts
Clutch cover
Clutch
Guide
Bar bolts
Guide Bar Bolts
Clutch
Steer the guide bar to under clutch
position.
Drive
Sprocket
Clutch
Engage chain in the groove on the guide bar.
Start on the top edge of the guide bar.
Bar Groove
Chain Drive
Links
3. Pull the choke control out fully.
4. Hold the body of the product on the ground
with your left hand.
5. Put your right foot through the rear handle.
6. Pull the starter rope handle slowly with your
right hand until you feel some resistance.
7. Pull the starter rope handle with force.
CAUTION:
Note:
Do not pull the throttle trigger when
you start the engine.
8. Continue to pull the starter rope handle
until the engine starts or tries to start (pull
max 6 times).
9. If the engine starts or tries to start, push the
choke control back fully position.
10.Continue to pull until the engine starts.
17
11.Hold the rear handle with your right hand
and the front handle with your left hand.
12.Immediately pull the front hand guard
rearward in the direction of the front handle
to disengage the chain brake.
Don’t pull the rope to its limit .
As this may cause the rope to break.
Don’t let the rope snap back.
Hold the handle and let the rope rewind slowly
There is no need to pull the rope briskly
There is no harsh resistance when pulling
Note:
The chain will move.
13.Run 20-30 seconds at elevated idle speed.
14.Pull the throttle trigger slowly but fully for
8-10 seconds, then release.
Make sure decompression valve in all the time.
Choke control
Choke control
