5
Display / Controller
Air purge screw
Air hole
Open
Close
1) Plug the power cord. Current temperature and the fuel amount are displayed.
2) Press the 'Power ON/OFF' button
- If Fan and Heating icons and current temperature, target temperature and fuel amount are
shown on the display, the LCD display is always lighted up
- This button is for turn on or turn off the unit
- The heater is operated in 8 seconds after fan is operated with blinking heating icon on the display.
※ When the current temperature is 2 ℃ higher than target temperature on the temp set or the
time reaches target time, the heater is turned off.
However, there might be no ignition for the first use since purchase with E1 displayed. Please
re-start the heater in this case. Automatic air purge device is equipped in the heater. Refer
to the followings when manually operating air purge device.
① Turn left the air purge screw 2~3 round.
② Re-operate the heater. (push the power button 2 times)
③ Bubble flows out of the air hole. In 10 seconds,
clean fuel flows out of the air hole.
④ Close the air purge screw when clean fuel flows out of the air
hole or ignited successfully.
⑤ Retry if not successful. (request service after 4 times failure)
▶ This product is designed not necessary to purge the air after
refueling when lack of fuel.
Caution : Do not open the air purge screw entirely.
Power ON/OFF
function
Temp
Temperature
set-refer to
category 4
Off Timer
Refer to category 5
Up and Down
function
Time
Time set-refer
to category 3
